Push Video MEGAPIXEL WIRELESS NETWORK CAMERA SERIES Manual de usuario descargar pdf (Pagina 16)

Note: When the configurations are saved successfully, you’ll see a message indicating the IP address

and port number assigned to this network camera.

3.3 Camera

3.3.1 Camera

Adjust the camera parameters if necessary.

Item Description

Title Enter the title for the camera with up to 15 alphabetic characters.

Snapshot Path Specify the location to save the snapshot pictures.

Environment Select the current environment for the camera to automatically adjust itself to produce the images suitable for the

selected environment.

Frame Rate The frame rate allowed to each viewer can be adjusted to adapt to the bandwidth on the network.

Set the desired image frequency to the maximum (FULL) or to a specified frame rate (1/2; 1/3; 1/4; 1/5; 1/10;

1/15).

The actual frame rate depends on the actual network connection, and may be lower than the specified one.

Power Line Frequency Select only when your camera video keeps flashing.

Stream Format Select the stream format to Single H.264 / Single MPEG-4 / Single Motion JPEG / Multi-Mode.

Note: Motion detection is not supported when the stream format is set to Motion JPEG.

MPEG4 / MJPEG Resolution Select the video resolution when the stream format is set to “MPEG4” or “MJPEG”.

The options are: VGA (640 x 480), QVGA (320 x 240), and QCIF (176 x 144).

OSD Select “ON” to show the camera title on the live view, or “OFF” to hide the camera title.

Slow Shutter Level This function is used to extend the exposure time for clearer images when the light is not sufficient.

Select 1 ~ 5 to extend the exposure time based on your current light condition. The larger the value, the longer

the exposure time, and the less the fps.

0 means function off.

3.3.2 Preset

Note: Before using this function, make sure the DPTZ function is enabled.

You can set new preset points (up to 16) or check existing points here.

How to set a new preset point

Step1: Click DPTZ icon.

Step2: Click to where you want to see, and you’ll get a 5x zoom-in image. To slightly zoom out, draw a square

from the bottom right to top left, and you’ll get a 3x image. Draw the square again and you’ll return to the

original size.

Step3: In “Current Position”, give a name to this point, and click “Add”.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

Sin comentarios

Push Video MEGAPIXEL WIRELESS NETWORK CAMERA SERIES Manual de usuario Pagina 16