
2
1.4 Rear Panel
Ethernet: Connect your network cable.
DC 5V: Connect the supplied regulated power supply.
Reset: With the power connected, press to reset all parameters, including the IP address to factory default
settings.
The camera will reboot after default reset. Please do not disconnect your camera during the reset
process.
External I/O Port A 6-pin I/O terminal is supplied with the camera for external alarm device connection. For details,
please refer to “1.5 External I/O Port” at page 2.
1.5 External I/O Port
This camera supports external I/O device connection, and a 6-pin I/O terminal is supplied with this camera for
easy connection.
Below shows which input on the I/O terminal you should use for wiring when you want to connect an external
device to this camera.
Alarm Out
Alarm In
RS485-A
RS485-B
GND
N/A
6-pin I/O Terminal Alarm Out Connection
1.6 Status Indicator
ICON
LAN connection status Internet connection status
System Status
During powering on Always on Always on
Blinking (on 250 ms, off 250 ms) Always off
Reset default
!"!"!"!"!"
Blinking (on 250 ms, off 250 ms) Blinking (on 250 ms, off 250 ms)
Upgrade
!"!"!"!"!" !"!"!"!"!"
Connection Status
LAN connected Always on --
Blinking (on 100 ms, off 500 ms) --
LAN disconnected
!""!""!""
Internet connected -- Always on
Blinking (on 100 ms, off 500 ms)
Internet disconnected --
!""!""!""
3G Connection Error on
iPhone / iPad / Android Mobile Device
--
Blinking
(on 5 sec, off 0.5 sec, on 0.5 sec, off 0.5 sec, on 5 sec)
3G Connection Setting
Uncompleted
-- !!!!"!"!!!!
Micro SD Card Status
Micro SD Card Error Keep current status for 20 sec $ Blinking for 3 sec $ Return to current status
* LED blinking frequency -
!
LED on /
"
LED off
Comentarios a estos manuales